We reply you within 12hours!
We make the quotations within 24 hours!
HC-Mold (Plastic & Metal) International Co., Ltd.
Tel: +86-769-85327002; +86-769-23566161
Fax: +86-769-85391842
Email: [email protected]
[email protected]
Massager:
The instruction and feature for double mould
点击数:101172011-10-26 14:55:01 来源: Rapid prototypes,making molds, mold tool,custom molding,mold makers HC-Mold
There are two kinds of double mould : one is over mould , the other one is double mould .
There are two kinds of double mould : one is over mould , the other one is double mould .
The over mould Is mean that injecting one part first , then telescope it to another mold and be to a new part .
Double color include independent double color and mix double color : independent double color is mean that make two kinds of color on one machine , usually finish it by displacing the cover mold(by turning mold ), A double mold need make two sets of mold, the same two sets of cavity , and different two sets of cover, two sets of mold base can be exchangeable ; Mix double color, just need one set of mold , need the special plastic machine, which is annex two piece of independent nozzle, and control the injection parameter of each nozzle independent .
Feature for double mould
a. Double mold need the matched injection machine
b. There are one rotation gear or slide gear .
c. There are difference between cover mold, but the cavity is the same.
d. Attention to the cylinder or other dynamic application
e. High requirement for precision
LAST PAGE1NEXT PAGE |